Digital versus analog
This page will explain the differences between analog and digital signals.
Radio, television, and telephone transmissions have, until recently, been sent through the air and over wires using electromagnetic waves. These waves are called analog because they have the same shapes as the light and sound waves produced by the transmitters. As light and sound waves change size and shape, the electrical signal that carries the transmission changes proportionately. In other words, the electromagnetic waves are analogous to the light and sound waves.
Analog bandwidth is measured by how much of the electromagnetic spectrum is occupied by each signal. The basic unit of analog bandwidth is hertz (Hz), or cycles per second. Typically, multiples of this basic unit of analog bandwidth are used, just as with digital bandwidth. Units of measurement that are commonly seen are kilohertz (KHz), megahertz (MHz), and gigahertz (GHz). These are the units used to describe the frequency of cordless telephones, which usually operate at either 900 MHz or 2.4 GHz. These are also the units used to describe the frequencies of 802.11a and 802.11b wireless networks, which operate at 5 GHz and 2.4 GHz.
While analog signals are capable of carrying a variety of information, they have some significant disadvantages in comparison to digital transmissions. The analog video signal that requires a wide frequency range for transmission cannot be squeezed into a smaller band. Therefore, if the necessary analog bandwidth is not available, the signal cannot be sent.
In digital signaling all information is sent as bits, regardless of the kind of information it is. Voice, video, and data all become streams of bits when they are prepared for transmission over digital media. This type of transmission gives digital bandwidth an important advantage over analog bandwidth. Unlimited amounts of information can be sent over the smallest or lowest bandwidth digital channel. Regardless of how long it takes for the digital information to arrive at its destination and be reassembled, it can be viewed, listened to, read, or processed in its original form.
It is important to understand the differences and similarities between digital and analog bandwidth. Both types of bandwidth are regularly encountered in the field of information technology. However, because this course is concerned primarily with digital networking, the term ‘bandwidth’ will refer to digital bandwidth.